Power Feed X-Axis 150 Lbs Torque for Bridgeport Type Milling Machines 0-200 RPM

Power Feed X-Axis 150 Lbs Torque for Bridgeport Type Milling Machines 0-200 RPM

These will fit almost any vertical knee-type mill out there with the 5/8" Shaft End, Including but not limited to Bridgeport, Precision Matthews, Grizzly, Enco, Jet, Sharp, Acer, Webb, GMC, Kent, Clark, Supermax, Enco, Turn Pro, Vectrax, Acra, Birmingham, Accu, First...etc. The gear ratio between the transmission plastic gear and motor shaft gear is not a whole number. The two gears will not mesh and wear at the same spot, this not only increases durability and longevity but even reduces noise over time.

Features:

•  X-axis power feed for Bridgeport-type milling machines
•  Reversible and auto shut-off at end of the cut
•  150 Lbs. torque
•  Variable speeds
•  Longer lifespan
•  Effortless operation
•  Limit switch for sensitive stop
•  No loss of dial or hand crank
•  Noiseless direction changes
•  Better surface smoothness
•  Small volume and easy installation
•  Excellent speed control in the entire range
•  The power table feed won't vibrate or strain in low speed
•  Direction control knob for easy and rapid operation
•  Safety feature to protect transmission gear and electronic components

• Type: X-axis
• Model: AS-250-150
• Voltage: 110 V, 60 Hz
• Torque: 150 lbs
• Rotate speed: 0-200 rpm
• Length: 33 cm (13 inches)
• Width: 20 cm (7.9 inches)
• Height: 18 cm (7 inches)
• Gross weight: 6.5 kg(14.3 lb)

• 1 x AS-250-150 X-Axis Power Feed for Milling Machine
• 1 x Set of Necessary Accessories
• 1 x User Manual